Search in Category
Cutting Head Components
Filter Your Search
Brand
Please note: All items are not yet available for use with our Filtered search.
If an item is not available via the filters, try searching for the specific part # or description.
If an item is not available via the filters, try searching for the specific part # or description.
Shop by Category
Loading...
Cutting Head Components
*Photos may not be the exact representation of products.
OmaxCutting Head Components
Viewing Page 3 of 8
(75 results)
OMC1 304954
Muff, Nozzle, Collision Sensing Terrain Follower, Polyester Foam, Black, 3 X 2.5 in.
This nozzle muff is narrower for use with a Terrain Follower and slides over the mixing tube to contain splash back from the cut stream and lower the noise level. Always
Omax
OMC1 305532-030
Mixing Tube, ROCTEC© 100, 0.030 in. ID X 4 in. Length
Used with MAXJET Nozzle. ROCTEC© 100 mixing tubes wear faster than ROCTEC© 500 mixing tubes.
Omax
OMC1 305604-015
Mixing Tube, Mini, ROCTEC© 500, 0.015 in. ID X 1.65 in. Length
Used with Mini MAXJET Nozzle.
Omax
OMC1 307448-14
Nozzle Assembly, Diamond, MAXJET 5i, 00.014 in. Orifice with 5 each 304351 Filter Assemblies 305617-14
Omax
OMC1 307507
Seal, Ring, Final Filter, White, Nylon, MAXJET 5 Series Nozzles
Omax
OMC1 307651-048
Mixing Tube, Fusible (breakaway), ROCTEC© 500, 0.048 in. ID X 4 in. Length
Use on A-Jet to lessen damage caused by collisions.
Omax
OMC1 308685
Screw, Shear, A-Jet
The shear screws on the A-Jet are designed to break away and reduce damage to other critical components inside the A-Jet assembly. These shear screws need to be replaced whenever damaged or once the machine faults due to a head crash.
Omax
OMC1 316505-030
Mixing Tube, Fusible (breakaway), ROCTEC© 500, 0.030 in. ID X 3 in. Length
For use on GlobalMAX machines only.
Omax
OMC1 316605-12
Orifice Assembly, Sapphire, GlobalMAX, 0.012 in.
For use with the 316500 Nozzle and a 20 Hp Pump.
Omax
OMC1 317384
Guard, Splash, Nozzle, Polyurethane, Yellow, ProtoMAX
This splash guard slides over the mixing tube to contain splash back from the cut stream and lower the noise level. The splash guard can be flipped up to check position and set standoff without having
Omax
