Collet Closers/Faceplates/Chucks

8" (203 mm) Top Reversible, 3-Jaw Chuck

The AC-125 provides up to 12,000 lb (53,379 N) of draw force, with 0.060" (1.5 mm) of travel, allowing part diameter variation of 0.015" (0.38 mm) without readjusting the collet. Its design is similar to the AC-25, but uses two pistons, which more than doubles the available draw force. A large internal spring is used for part release. The AC-125 can be tightened from the rear, and provides a 5/16" (8 mm) through-hole. Its compact size allows it to be used with all models of HA5Cs, and with the use of a small spacer, it can be operated vertically. Clamping force is varied by regulating air pressure supplied to the unit. The AC-125 air collet closer can be used with all types of 5C collets, including step collets. Includes one closer for each head on multi-head units.125 pneumatic collet closer, collets can be clamped and unclamped with the flip of a lever.

AC-100 Collet Closer, spring clamp, air release. 1.06" Dia. thru-hole, up to 10,000 lb of draw force, with 0.025" travel. allows for part variation of 0.006". Cannot be used vertically, not for tilting HA5Cs.

AC-25 Collet Closer, fits entirely inside the HA5C for Vert or Horizontal use. Air Clamp with holding power of up to 3000 lb., 0.030" of travel, This unit does not have a Thru-Hole.

FP11 is an 11" Faceplate with an A6 Spindle Mount

10" Manual 3 Jaw Chuck With Reversible Jaws. Includes Adapter Plate & Mounting Hardware for T-Slot Platter On Haas HRT310 Rotary Table

This manual 6" 3-jaw chuck with reversible jaws for Haas HRT160 Series rotary products includes the adapter plate and hardware to mount the chuck on the T-slot platter of the rotary.

A616C, A 16C Collet Chuck for use with your Haas HRTA6 Rotary Table. Must Purchase an A6AC Pneumatic Draw Tube Assembly Separately to Actuate the Collet.

A65C, A 5C Collet Chuck for use with your Haas HRTA6 Rotary Table. Must Purchase an A6AC Pneumatic Draw Tube Assembly Separately to Actuate the Collet.

The A6AC pneumatic draw-tube assembly has a 1.75" thru-hole and works with A65C and A616C collet chucks to provide 5C or 16C air collet closing capabilities for the HRTA6. With the A6AC, collets can be clamped with the flip of a lever. The A6AC is also co